The following instruction were written for removing the CRT from 1988 & 1989 model Reattas.
Quick Summary:
- Carefully remove the trim piece surrounding the CRT.
- Remove 4 Torx screws holding the unit in place.
- Slide unit out about 3/4 way.
- Unsnap the red clip, pull apart black harness.
The harness may not always have clips holding it in place.
Detailed Instructions:
Sitting in the driver's seat, grasp the bezel with your fingers that is over the instrument cluster by the horizontal bar that runs between the speedometer and warning lights. there are four clips; it will pull right off.
Along the right side of the instrument cluster, you will see four screws. it's pretty dark in there; you may want to do this by feel.
Two of the screws hold in the right side of the instrument cluster; don't bother those. You will feel two "feet" that come from the bezel that is over the CRT; take those two screws out. There are two clips on the right side of the CRT bezel; just carefully slide a thin flat blade screwdriver under the right side of the bezel, and it will snap right off.
The CRT is secured in the dash by four 7MM/#15 Torx screws. Remove the screws, and slide the CRT out. Disconnect the brown and blue plugs, and you're done.
Thanks to members of the Reattas forum for this information.
