Advertisement
IMPORTANT NOTICE:
We are not experts or professionals in any field. Any advice or information found on this website should not be considered as 100% accurate and is provided on an AS-IS basis. Use any information you find here at your own risk. Click here and carefully read and agree to the DISCLAIMER statements before using any information found on this website.


back button
Knock Sensor Removal
Print 
Written by AACA Reatta Forum Members
Monday, 04 October 2010
 
The knock sensor is located on the engine block below the rear cylinder head. It is on the passenger side, near the oil pressure switch.
  • Disconnect the wire connector from the sensor.
  • Use an appropriately sized wrench to screw it out.

You do not need to drain any coolant to install the knock sensor.


 

 
 

Last Updated Monday, 12 September 2011

Add your comments:

Please use the form below to add your comments or corrections to this article.
(Comments must be approved by the website administrator before they are published)

Comment:


Security code Click here to refresh security code

Enter security code in the box below

< Prev   Next >
[ Back ]

IMPORTANT NOTICE:
We are not experts or professionals in any field. Any advice or information found on this website should not be considered as 100% accurate and is provided on an AS-IS basis. Use any information you find here at your own risk. Click here and carefully read and agree to the DISCLAIMER statements before using any information found on this website.

Help Support Us

Enter Amount:

Advertisements

 
Click here for more info.
Your ad here

Latest Tips and Tutorials


(Click the page numbers above for more Reatta parts)